Comments on: The NPF driver isn't running – Wireshark

By: Bhabani

Bhabani — Sat, 31 Dec 2011 20:47:30 +0000

ThanX guys…. U guys are such a help… I have been looking for this soln for quite sometime

By: Simon J

Simon J — Fri, 11 Nov 2011 21:58:03 +0000

The way that worked for me was:
Right Click on Short Cut, Properties, Compatability Tab, where it says Privilege Level, tick “run this program as an administrator”.

By: Fiona

Fiona — Tue, 18 Oct 2011 08:07:37 +0000

I just reinstalled my pc, then the WireShark didn’t work for me …even after doing what you suggested…cmd said server invalid

By: Thanks

Thanks — Mon, 03 Oct 2011 04:45:15 +0000

Thanks a lot

By: Orlando Canino

Orlando Canino — Mon, 26 Sep 2011 09:28:01 +0000

Works OK. Win 7, installed Wireshark, worked fine the first time the program is runned. Turn off the PC, turn on, start Wireshark and since then message “NPF driver not found” is shown.

Tried : “net start npf” from command prompt, but doesnt work, says “Access denied”.

Right click on shortcut, properties, enable “run as admin”, ok. Then click on shortcut and goes OK.

By: SomeOne

SomeOne — Sun, 11 Sep 2011 12:45:30 +0000

Thanks, it worked

By: Rajesh

Rajesh — Fri, 01 Jul 2011 18:52:51 +0000

By running as an administrator i am able to find the interfaces but the packet sniffing does not show up, kindly share your thoughts.

By: Jared Heinrichs

Jared Heinrichs — Wed, 15 Jun 2011 14:46:41 +0000

You’re welcome. You should check out the rest of my site and maybe add my RSS feed to your reading Have a good one.

By: Walt

Walt — Wed, 15 Jun 2011 12:50:45 +0000

Where ever you all may be .. Thanks dudes! net stat npf worked for me

By: Jared Heinrichs

Jared Heinrichs — Tue, 14 Jun 2011 13:52:35 +0000

“net start npf” is needed to be run from a command prompt. Right click a shortcut to the command prompt and tell it to run as an administrator. A little black command prompt window will open. type those three words exactly how you see them including the spaces. It will work.